Configuring Mpls Components; Configuring Global Mpls Parameters - Alcatel-Lucent 7450 Manual

Configuring MPLS Components

Configuring MPLS Components

Use the MPLS and RSVP CLI syntax displayed below for:

Configuring Global MPLS Parameters

Admin groups can signify link colors, such as red, yellow, or green. MPLS interfaces
advertise the link colors it supports. CSPF uses the information when paths are computed for
constrained-based LSPs. CSPF must be enabled in order for admin groups to be relevant.
To configure MPLS admin-group parameters, enter the following commands:
CLI Syntax: if-attribute
The following displays an admin group configuration example:
ALA-1>config>router>if-attr# info
----------------------------------------------
----------------------------------------------
A:ALA-1>config>router>mpls# info
----------------------------------------------
...
----------------------------------------------
A:ALA-1>config>router>mpls#
Page 176
• Configuring Global MPLS Parameters on page 176
• Configuring an MPLS Interface on page 177
• Configuring MPLS Paths on page 178
• Configuring an MPLS LSP on page 179
• Configuring a Static LSP on page 180
• Configuring Manual Bypass Tunnels on page 181
• Configuring RSVP Parameters on page 183
• Configuring RSVP Message Pacing Parameters on page 184
• Configuring Graceful Shutdown on page 185
admin-group group-name value group-value
mpls
frr-object
resignal-timer minutes
admin-group "green" value 15
admin-group "yellow" value 20
admin-group "red" value 25
resignal-timer 500
7450 ESS MPLS Guide