Alcatel-Lucent 7450 Manual page 233

p2mp-s2-fast-retry
Syntax p2mp-s2-fast-retry seconds [1..10] seconds
no p2mp-s2-fast-retry
Context config>router>rsvp
Description
This command configures a global parameter to allow the user to apply a shorter retry timer for the
first try after an active LSP path went down due to a local failure or the receipt of a RESVTear. This
timer is used only in the first try. Subsequent retries will continue to be governed by the existing LSP
level retry-timer.
Default
0 (disabled)
preemption-timer
Syntax preemption-timer seconds
no preemption-timer
Context config>router>rsvp
Description This parameter configures the time in seconds a node holds to a reservation for which it triggered the
soft pre-emption procedure.
The pre-empting node starts a separate preemption timer for each pre-empted LSP path. While this
timer is on, the node should continue to refresh the Path and Resv for the pre-empted LSP paths.
When the preemption timer expires, the node tears down the reservation if the head-end node has not
already done so.
A value of zero means the LSP should be pre-empted immediately; hard pre-empted.
The no form of this command reverts to the default value.
Default 300
Parameters seconds — Specifies the time, in seconds, of the preemption timer.
label-map
Syntax [no] label-map in-label
Context config>router>mpls>interface
Description
This command is used on transit routers when a static LSP is defined. The static LSP on the ingress
router is initiated using the config router mpls static-lsp lsp-name command. An in-label can be
associated with either a pop or a swap action, but not both. If both actions are specified, the last
action specified takes effect.
The no form of this command deletes the static LSP configuration associated with the in-label.
7450 ESS MPLS Guide
Values 0 — 1800 seconds
MPLS and RSVP
Page 233