Alcatel-Lucent 7450 Manual page 410

-----------------------------------------------------------------------
trap-suppress
Syntax trap-suppress number-of-traps time-interval
Context tools>perform>router>mpls
Description This command modifies thresholds for trap suppression. The time-interval parameter is used to sup-
press traps after a certain number of traps have been raised within a period. By executing this com-
mand, there will be no more than number-of-traps within time-interval.
Parameters number-of-traps — Specifies to suppress the number of traps raised within a period.
time-interval — Specifies to suppress a certain number of traps raised within a period.
update-path
Syntax update-path {lsp lsp-name path current-path-name new-path new-path-name}
Context tools>perform>router>mpls
Description This command enables you to instruct MPLS to replace the path of a primary or secondary LSP. The
primary or secondary LSP path is indirectly identified via the current-path-name value. The same
path name cannot be used more than once in a given LSP name.
This command applies to both CSPF LSP and to a non-CSPF LSP. This command will only work
when the specified current-path-name has the adaptive option enabled. The adaptive option can be
enabled at the LSP level or the path level.
The new path must have been configured in the CLI or provided via SNMP. The CLI command for
entering the path is
configure router mpls path path-name
The command fails if any of the following conditions exist:
When you execute this command, MPLS performs the following procedures:
Page 410
(6) * Label : 131071
Total RSB Count : 2
Values 100 — 1000, in multiples of 100
Values 1 — 300
• The specified current-path-name of this LSP does not have the adaptive option enabled.
• The specified new-path-name value does not correspond to a previously defined path.
• The specified new-path-name value exists but is being used by any path of the same LSP, includ-
ing this one.
• MPLS performs a single MBB attempt to move the LSP path to the new path.
• If the MBB is successful, MPLS updates the new path
7450 ESS MPLS Guide