Alcatel-Lucent 7450 Manual page 476

GMPLS Commands
Default
0
Parameters seconds — Specifies the time, in seconds, for the LSP to attempt reversion after failure.
shutdown
Syntax [no] shutdown
Context config>router>gmpls>lsp
Description This comand administratively enables or disables the GMPLS LSP.
Default shutdown
switching-type
Syntax switching-type switching-type
no switching-type
Context config>router>gmpls>lsp
Description This command configures the type of switching required for the gLSP. As defined in RFC 3471. The
default CLI value is ethernet, which indicates that Digital Channel Switch Capable (DCSC) should be
signaled. Ethernet is the only supported value in Release 13.0.
Default ethernet
Parameters
switching-type — Specifies the required type of switching.
to
Syntax to ip-address
Context config>router>gmpls>lsp
Description This command specifies the GMPLS loopback address of the far-end UNI-C router for a GMPLS
LSP. When creating a GMPLS LSP, this command is mandatory.
Parameters ip-address — Specifies the system IP address of the far-end UNI-C router.
Page 476
Values
0 — 1800
Default 0
Values ethernet
7450 ESS MPLS Guide