LDP Configuration Management Tasks
LDP Configuration Management Tasks
This section discusses the following LDP configuration management tasks:
•
•
•
•
Disabling LDP
The no ldp command disables the LDP protocol on the router. All parameters revert to the default
settings. LDP must be shut down before it can be disabled.
Use the following command syntax to disable LDP:
CLI Syntax: no ldp
Page 634
Disabling LDP on page 634
Modifying Targeted Session Parameters on page 635
Modifying Interface Parameters on page 636
Modifying Interface Parameters on page 636
shutdown
7450 ESS MPLS Guide