Alcatel-Lucent 7450 Manual page 232

MPLS Commands
p2p-merge-point-abort-timer
Syntax p2p-merge-point-abort-timer [1.. 65535] seconds
no p2p-merge-point-abort-timer
Context config>router>rsvp
Description
This command configures a timer to abort Merge-Point (MP) node procedures for a P2P LSP path.
When a value higher than zero is configured for this timer, it will enter into effect anytime this node
activates Merge-Point procedures for one or more P2P LSP paths. As soon an ingress interface goes
operationally down, the Merge-Point node starts the abort timer. Upon expiry of the timer, MPLS will
clean up all P2P LSP paths which ILM is on the failed interface and which have not already received
a Path refresh over the bypass LSP.
Default 0 (disabled)
p2mp-merge-point-abort-timer
Syntax p2mp-merge-point-abort-timer [1.. 65535] seconds
no p2mp-merge-point-abort-timer
Context config>router>rsvp
Description
This command specifies a configurable timer to abort Merge-Point (MP) node procedures for an S2L
of a P2MP LSP instance. When a value higher than zero is configured for this timer, it will enter into
effect anytime this node activates Merge-Point procedures for one or more P2MP LSP S2L paths. As
soon an ingress interface goes operationally down, the Merge-Point node starts the abort timer. Upon
expiry of the timer, MPLS will clean up all P2MP LSP S2L paths which ILM is on the failed
interface and which have not already received a Path refresh over the bypass LSP.
Default
0 (disabled)
p2p-active-path-fast-retry
Syntax p2p-active-path-fast-retry seconds [1..10] seconds
no p2p-active-path-fast-retry
Context config>router>rsvp
Description This command configures a global parameter to allow the user to apply a shorter retry timer for the
first try after an active LSP path went down due to a local failure or the receipt of a RESVTear. This
timer is used only in the first try. Subsequent retries will continue to be governed by the existing LSP
level retry-timer.
Default 0 (disabled)
Page 232 7450 ESS MPLS Guide