Ler Configuration For Mpls-Tp - Alcatel-Lucent 7450 Manual

Configuring MPLS-TP
The if-num-validation command is used to enable or disable validation of the if-num in LSP
Trace packet against the locally configured if-num for the interface over which the LSP Trace
packet was received at the egress LER. This is because some implementations, do not perform
interface validation for unnumbered MPLS-TP interfaces and instead set the if-num in the dsmap
TLV to 0. The default is enabled.

LER Configuration for MPLS-TP

LSP and Path Configuration
MPLS-TP tunnels are configured using the mpls-tp LSP type at an LER under the LSP
configuration, using the following CLI tree:
config
router
mpls
Page 86
[no] if-num <if-num>
[no] if-num-validation [enable|disable]
...
exit
lsp <xyz> [bypass-only|p2mp-lsp|mpls-tp <src-tunnel-num>]
to node-id {<a.b.c.d> | <1.. .4,294,967,295>}
dest-global-id <global-id>
dest-tunnel-number <tunnel-num>
[no] working-tp-path
lsp-num <lsp-num>
in-label <in-label>
out-label <out-label> out-link <if-name>
[next-hop <ipv4-address>]
[no] mep
[no] oam-template <name>
[no] bfd-enable [cc | cc_cv]
[no] shutdown
exit
[no] shutdown
exit
[no] protect-tp-path
lsp-num <lsp-num>
in-label <in-label>
out-label <out-label> out-link <if-name>
[next-hop <ipv4-address> ]
[no] mep
[no] protection-template <name>
[no] oam-template <name>
[no] bfd-enable [cc | cc_cv]
[no] shutdown
exit
[no] shutdown
exit
// defaults to cc
//defaults to cc
7450 ESS MPLS Guide