Alcatel-Lucent 7450 Manual page 259

protection-template
Syntax protection-template name
no protection-template
Context config>mpls>lsp>protect-tp-path
Description
This command applies a protection template name to an MPLS-TP LSP that the protect path is
configured under. If the template is applied, then MPLS-TP 1:1 linear protection is enabled on the
LSP, using the parameters specified in the named template.
A named protection template can only be applied to the protect path context of an MPLS-TP LSP.
The no form of the command removes the template and thus disables mpls-tp linear protection on the
LSP.
Default no protection-template
Parameters name — Specifies at text string for the template up to 32 characters in printable 7-bit ASCII, enclosed
exclude
Syntax [no] exclude group-name [group-name...(up to 5 max)]
Context config>router>mpls>lsp
Description This command specifies the admin groups to be excluded when an LSP is set up in the primary or
secondary contexts. Each single operation of the exclude command allows a maximum of 5 groups to
be specified at a time. However, a maximum of 32 groups can be specified per LSP through multiple
operations. The admin groups are defined in the config>router>if-attribute>admin-group context.
Use the no form of the command to remove the exclude command.
Default no exclude
Parameters
group-name — Specify the existing group-name to be excluded when an LSP is set up.
exclude-node
Syntax [no] exclude-node ip-address
Context config>router>mpls>lsp
Description This command enables the option to include XRO object in the bypass LSP PATH message object.
The exclude-node option is required for manual bypass LSP with XRO to FRR protect ABR node in
a multi-vendor network depolyment. This command must be configured on the PLR node that
protects the ABR node. The ABR node IP address must be configured as exclude-node.
Default no exclude-node
7450 ESS MPLS Guide
in double quotes.
MPLS and RSVP
Page 259