Alcatel-Lucent 7450 Manual page 116

Diff-Serv Traffic Engineering
RSVP Interface Level
The following are the configuration steps at the RSVP interface level:
1. The operator configures the percentage of RSVP interface bandwidth each CT shares, for
2. The operator can overbook (underbook) the maximum reservable bandwidth of a given
3. .Both the BC value and the subscription parameter can be changed at any time.
LSP and LSP Path Levels
The following are the configuration steps at the LSP and LSP path levels:
1. The operator configures the CT in which the LSP belongs by configuring the class-type
2. Only one CT per LSP path is allowed per RFC 4124, Protocol Extensions for Support of
3. The signaled CT of a dynamic bypass must always be CT0 regardless of the CT of the
4. The operator cannot configure the CT, setup priority, and holding priority of a manual
Page 116
interface level and the interface specific configured value overrides the global configured
value. The BC value can be changed at any time. The operator can specify the BC for a CT
which is not used in any of the TE class definition but that does not get used by any LSP
originating or transiting this node.
d. Configuration of the Admission Control Policy to be used: only the Maximum
Allocation Model (MAM) is supported. The MAM value represents the bandwidth
constraint models for the admission control of an LSP reservation to a link.
example, the BC, using the class-type-bw command. The value entered at the interface
level overrides the global value configured under the diffserv-te node.
CT by overbooking (underbooking) the interface maximum reservable bandwidth via
configuring the appropriate value for the subscription percentage parameter in the
config>router>rsvp>interface context.
ct-number command at the LSP level and/or the path level. The path level value overrides
the LSP level value. By default, an LSP belongs to CT0.
Diffserv-aware MPLS Traffic Engineering. A multi-class LSP path is achieved through
mapping multiple system Forwarding Classes to a CT.
primary LSP path. The setup and hold priorities must be set to default values, for example,
7 and 0 respectively. This assumes that the operator configured a couple of TE classes, one
which combines CT0 and a priority of 7 and the other which combines CTO and a priority
of 0. If not, the bypass LSP will not be signaled and will go into the down state.
bypass. They are always signaled with CT0 and the default setup and holding priorities.
7450 ESS MPLS Guide