Cable Routing For Booksize Base Cabinets And Booksize Cabinet Kit; Cable Routing For Motor Modules In The Chassis Format - Siemens SINAMICS S120 Manual

Electrical installation
4.4 Connections
4.4.11.6

Cable routing for Booksize Base Cabinets and Booksize Cabinet Kit

Note
The procedure is the same as that for the Cabinet Modules Motor Module in chassis format.
(→ See the Section titled "Cable routing for Motor Modules in chassis format")
Cable routing of motor cable
Note
The motor cables are easy to connect to terminals in the lower part of the customer
connection area.
4.4.11.7

Cable routing for Motor Modules in the chassis format

For the Motor Modules in chassis format, the customer must carry out the following cabling
or connection work:
Table 4- 17
Cable routing
PROFIBUS cables to the Control Unit
DRIVE-CLiQ connections / signal cables to the Control Unit
Signal cables to the customer terminal block –X55
Option K82, terminal module for controlling safety functions "Safe Torque Off" and
"Safe Stop 1"
Option K87, Terminal Module TM54F
Signal cables to Sensor Modules SMC10/20/30 (-B81/-B82/-B83)
Cable connection between motor and Motor Module
Notice:
The "Basic rules for cable routing" and "Preparatory steps" described above must
be observed whenever any cabling or connection work is performed!
108
Checklist for cabling or connection work for Motor Modules in the chassis format
Completed?
Cabinet Modules
Manual, (GH5), 05/2010, A5E03263538A