Siemens SINAMICS S120 Manual page 94

Modular motion control drive

Hide thumbs Also See for SINAMICS S120:

Table of Contents

Electrical installation

4.4 Connections

Cable routing for PROFIBUS connection to the Control Unit

1. Feed the cable for the Control Unit into the cabinet from the bottom left.

2. Remove approx. 3 cm of the cable insulation at the level of the shield plate in the lower

3. To secure the cable in accordance with EMC requirements, snap the clip onto the shield

4. Use cable ties to secure the cable at suitable points.

5. Feed the cable up through the cabinet and, when it reaches the Control Unit, guide it up

6. Use cable ties to secure the cable at suitable points.

7. Connect the cable to the Control Unit.

part of the cabinet and attach the cable.

and to the right towards the Control Unit. When doing so, route the cable in a similar

manner to the standard cables that have already been installed in the cabinet.

(→See SINAMICS S120 Manual GH1 Control Units)

Manual, (GH5), 05/2010, A5E03263538A

Cabinet Modules

Show Quick Links

Table of Contents