Siemens SINAMICS S120 Manual page 105

Cable routing for DRIVE-CLiQ connections and signal cables, frame sizes HX+HI and JX+JI
1. Feed the cable for the DRIVE-CLiQ/signal cables into the cabinet from the bottom left.
2. Use cable ties to secure the cable at suitable points.
3. Feed the cable up through the cabinet and, when it reaches the Control Unit, guide it up
4. Use cable ties to secure the cable at suitable points.
5. Connect DRIVE-CLiQ or signal cable to the Control Unit.
Cabinet Modules
Manual, (GH5), 05/2010, A5E03263538A
Frame size:
HX+HI
and to the right towards the Control Unit. When doing so, route the cable in a similar
manner to the standard cables that have already been installed in the cabinet.
JX+JI
Electrical installation
4.4 Connections
105