Installation; Switch Settings; Table 1-2 Switch Settings - NEC Electra Elite IPK Installation And Maintenance Manual

Electra Elite IPK
___________________________________________________________________________________
2.3
2.4
___________________________________________________________________________________
SPE Hardware, Installation, and Maintenance Manual

Installation

Only one SPE(M)-U( ) ETU can be installed in the system. The SPE(M)-U( )
ETU can be installed in the following slots: AP, S1 or S2. When the modem is
used the SPE(M)-U( ) ETU must be installed in the S1 or S2 slot.

Switch Settings

Switch Setting
On COM – D acting as a DCE (Default)
SW 1
Off COM – D Acting as a DTE
On COM – C acting as a DCE (Default)
SW 2
Off COM – C Acting as a DTE
SW 3 NA Reset the SPE(M)-U( ) ETU
On Not Used
SW 4-1
Off Not Used (Default)
On Restores Card to Factory Defaults
SW 4-2
Off Save Settings (Default)
On Not Used
SW 4-3
Off Not Used (Default)
On Not Used
SW 4-4
Off Not Used (Default)
On Not Used
SW 4-5
Off Not Used (Default)
On Not Used
SW 4-6
Off Not Used (Default)
On Enables Debug through COM 1 of the KSU
SW 4-7
Off Debug is disabled through COM 1 of KSU (Default)
On MIFM Mode Only ( Emulates MIFM; SPE features are
disabled)
SW 4-8
Off SPE Mode (Default)

Table 1-2 Switch Settings

Description
Document Revision 1
1 - 5