Configuring An Allowed Domain Id List - HP FlexFabric 5700 Series Configuration Manual

In a stable fabric, the configured priority does not take effect immediately. Therefore, the runtime priority
of a switch might be different from the configured priority. To make the configured priority take effect, use
the domain restart disruptive command to perform a disruptive reconfiguration. After a disruptive
reconfiguration, the runtime priority could still be different from the configured priority, depending on the
configured priority value, as shown in
Table 3 Configured priority and runtime priority mappings
Configured priority
≤ 2
> 2
To set the switch priority:
Step
1. Enter system view.
2. Enter VSAN view.
3. Set the switch priority in the
VSAN.

Configuring an allowed domain ID list

To successfully configure an allowed domain ID list on the principal switch, make sure all assigned and
locally configured domain IDs are included in the list. After you configure an allowed domain ID list, the
principal switch assigns only domain IDs available in the allowed list.
To successfully configure an allowed domain ID list on a non-principal switch, make sure the runtime
domain ID of the switch is included in the allowed list. After you configure an allowed domain ID list on
a non-principal switch, the following rules apply:
• The locally configured domain ID must be included in the allowed list. Otherwise, the domain ID
configuration fails.
The principal switch must assign a domain ID that is included in the allowed list of the non-principal
•
switch. Otherwise, the non-principal switch refuses the assigned domain ID and isolates its interface
connected to the principal switch.
HP recommends that you configure the same allowed domain ID list for all switches in a VSAN.
To configure an allowed domain ID list:
Step
4. Enter system view.
5. Enter VSAN view.
6. Configure an allowed domain
ID list for the VSAN.
Table 3.
Running priority
•
Principal switch—Same as the configured priority.
•
Non-principal switch—3.
•
Principal switch—2.
•
Non-principal switch—Same as the configured priority.
Command
system-view
vsan vsan-id
priority value
Command
system-view
vsan vsan-id
allowed-domain-id
domain-id-list
37
Remarks
N/A
N/A
The default setting is 128.
Remarks
N/A
N/A
By default, the allowed domain IDs are 1
to 239.