Configuring Pw Redundancy For H-Vpls Access - HP 12500 Series Configuration Manual

After you complete previous configurations, issue the display vpls connection command on the PEs.
You will see that a PW connection in up state has been established.

Configuring PW redundancy for H-VPLS access

Network requirements
As shown in
and NPE 2. Establish an N-PW between NPE 1 and NPE 3 and another N-PW between NPE 2 and NPE
3.
Configure a VPLS instance that supports H-VPLS network. On UPE and NPE 3, configure a service
instance and bind it to the VPLS instance. The service instance matches the received packets that carry
VLAN tag 100 on GigabitEthernet 3/0/1. The matched packets are forwarded by the VPLS instance.
Figure 39 Network diagram
Configuration procedure
Configure the IGP protocol on the MPLS backbone, which is OSPF in this example. (Details not
1.
shown)
Configure UPE.
2.
# Configure basic MPLS.
<Sysname> system-view
[Sysname] sysname UPE
[UPE] interface loopback 0
[UPE-LoopBack0] ip address 1.1.1.1 32
[UPE-LoopBack0] quit
[UPE] mpls lsr-id 1.1.1.1
[UPE] mpls
[UPE-mpls] quit
[UPE] mpls ldp
[UPE-mpls-ldp] quit
# Configure an IP address for the interface connected to NPE 1, and enable MPLS and MPLS LDP.
[UPE] interface vlan-interface 12
Figure 39, establish a U-PW between UPE and NPE 1 and a backup U-PW between UPE
153