Transmission Disassembly - ATSG FORD 4R100 Manual

Technical Service Information
F o rd
-B A
P- 7 0 0 6
R FF 8 1
9 8
DIGITAL TRANSMISSION
RANGE SENSOR
Copyright © 2003 ATSG
Figure 43
Copyright © 2003 ATSG
Figure 44
OUTPUT SHAFT
SPEED SENSOR
Copyright © 2003 ATSG
Figure 45
AUTOMATIC TRANSMISSION SERVICE GROUP
External Components
1. Remove the turbine shaft from the transmission
as shown in Figure 42. Inspect the spline area
on both ends and set aside for final assembly.
2. Remove the two Digital Transmission Range
sensor retaining bolts, as shown in Figure 43,
and remove the DTR sensor.
3. If equipped, the turbine shaft speed sensor and
RETAINING
output shaft speed sensor must be removed to
BOLTS (2)
prevent damage, as shown in Figure 44 and 45.
4. Install a compatible holding fixture onto the
transmission case, as shown in Figure 46, that
will allow you to safely rotate the transmission
when installed in the bench fixture.
5. Rotate the transmission so that the bottom pan
is facing up, as shown in Figure 47.
TURBINE SHAFT
SPEED SENSOR

TRANSMISSION DISASSEMBLY

Continued on Page 42.
F o rd
-B A
P- 7 0 0 6
R FF 8 1
9 8
Figure 46
TRANSMISSION
HOLDING FIXTURE
Copyright © 2003 ATSG
41