ATSG FORD 4R100 Manual page 113

Figure 200
OUTPUT SHAFT
SPEED SENSOR
Figure 201
"4R100" COOLER BYPASS
VALVE ASSEMBLY
OEM PART NUMBER
F81Z-7H322-AA
Rear
"From Cooler"
Sealing Washers
Technical Service Information
TURBINE SHAFT
SPEED SENSOR
Copyright © 2003 ATSG
Copyright © 2003 ATSG
Figure 202
AUTOMATIC TRANSMISSION SERVICE GROUP
FINAL ASSEMBLY
External Components (Cont'd)
4. Install turbine shaft speed sensor, if equipped,
as shown in Figure 200, and torque the bolt to,
8-10 N·m (71-88 in.lb.).
5. Install output shaft speed sensor, if equipped,
as shown in Figure 201, and torque the bolt to,
8-10 N·m (71-81 in lb.)
Note: The TSS and OSS are model dependant.
6. Install the cooler bypass valve with the sealing
washers positioned as shown in Figure 202,
and install threaded cooler line case fittings.
7. Torque front fitting to, 30 N·m (22 ft.lb.).
Torque rear fitting to, 36 N·m (27 ft.lb.)
Continued on Page 114.
COOLER LINE
FITTINGS
Front
"To Cooler"
Sealing Washers
Copyright © 2003 ATSG
113