ATSG FORD 4R100 Manual page 46

TRANSMISSION DISASSEMBLY
Internal Components (Cont'd)
7. Remove the coast clutch housing, as shown in
Figure 58, and set aside for component rebuild
section.
Note: There are three different versions of
the coast clutch housing, which we will show
you in the component rebuild section. Shown
here is the PTO version.
8. Remove the overdrive clutch backing plate
snap ring, as shown in Figure 59, using a large
screwdriver.
Note: This snap ring is a selective thickness
and should be measured at this time.
9. Remove the overdrive clutch backing plate and
overdrive clutch pack, as shown in Figure 59.
Continued on Page 47.
46
Technical Service Information
COAST CLUTCH
HOUSING ASSEMBLY
FOR "PTO" MODELS
Copyright © 2003 ATSG
Figure 58
AUTOMATIC TRANSMISSION SERVICE GROUP
35
31 OVERDRIVE CLUTCH BACKING PLATE SNAP RING (SELECTIVE)
34 OVERDRIVE CLUTCH BACKING PLATE
35 OVERDRIVE CLUTCH FRICTION PLATES
Figure 59
31
34
36
Copyright © 2003 ATSG