ATSG FORD 4R100 Manual page 60

EXTENSION
HOUSING
EXTENSION
HOUSING GASKET
60
Technical Service Information
EXTENSION HOUSING
RETAINING BOLTS
OUTPUT
SHAFT
Copyright © 2003 ATSG
Figure 92
AUTOMATIC TRANSMISSION SERVICE GROUP
COMPONENT REBUILD
Transmission Case Assembly (Cont'd)
25. Install new extension housing gasket on case
surface, as shown in Figure 92.
26. Install the 4WD extension housing, as shown
in Figure 92.
Note: The 4R100 unit requires an extension
housing with the added boss, or shoulder
(4X4), as illustrated in Figure 94, to retain
the lube orifice plug. If replacement becomes
necessary, refer to Figure 94 for a proper
replacement.
27. If installing a 2WD version extension housing,
install a new rear seal using the proper driver.
28. Install extension housing and retaining bolts, as
shown in Figure 92.
29. Torque the extension housing bolts, as shown
in Figure 93 to 41-54 N·m (30-40 ft.lb.).
Continued on Page 62.
Figure 93
Copyright © 2003 ATSG