ATSG FORD 4R100 Manual page 97

USED WITH THE "CAST IRON"
COAST CLUTCH DRUM
RETAINING
BOLTS (3)
OIL PUMP
COVER
RF-F81P-7B324-AA
Ford Ford
Figure 165
Technical Service Information
COAST CLUTCH
SEAL RINGS ARE
LOW ON PUMP TOWER
(LIKE E4OD)
Figure 164
COAST CLUTCH
SEAL RINGS (2)
OIL PUMP
STATOR SHAFT
ASSEMBLY
Copyright © 2003 ATSG
AUTOMATIC TRANSMISSION SERVICE GROUP
USED WITH THE "STAMPED STEEL"
COAST CLUTCH DRUM
Oil Pump Body And Cover Assembly (Cont'd)
11. If removal was necessary because of damage,
refer to Figure 164, to ensure the replacement
part is correct.
12. Install the stator shaft assembly into the pump
cover, as shown in Figure 165, and torque the
3 retaining bolts to 9-11 N·m (80-100 in.lb.),
as shown in Figure 166.
13. Install the two coast clutch sealing rings into
their grooves in the stator shaft assembly, as
shown in Figure 165.
Continued on Page 98.
RF-F81P-7B324-AA
Ford Ford
Figure 166
COAST CLUTCH
SEAL RINGS ARE HIGHER
ON THE PUMP TOWER
Copyright © 2003 ATSG
Copyright © 2003 ATSG
97