Manual Valve Check - ATSG FORD 4R100 Manual

Figure 194
Manual Valve should protrude .050" past
the rear of valve body casting, with the
manual lever in the reverse position.
P R N D 2 1
MANUAL VALVE
Figure 195
Technical Service Information
RETAINING NUTS (2)
RETAINING BOLTS (11)
ACCUMULATOR
VALVE BODY
Copyright © 2003 ATSG
Approx .050"
Copyright © 2003 ATSG
AUTOMATIC TRANSMISSION SERVICE GROUP
FINAL ASSEMBLY
Bottom Pan Components (Cont'd)
12. Install the accumulator valve body, as shown in
Figure 194, install 11 retaining bolts and the
two nuts and hand tighten at this time.
Note: Refer to Valve Body Bolt Chart found
on Page 116 for proper locations.
13. Finish tightening the bolts and nuts on the
accumulator body (11 bolts, 2 nuts), main
control valve body (14 bolts, two nuts), the
solenoid body (9 bolts, one nut) and reinforcing
plate (3 bolts).
Note: Refer to Valve Body Bolt Chart found
on Page 116 for proper locations.
14. Torque all valve body bolts and nuts, as shown
in Figure 195 to: 9-11 N·m (80-100 in.lb.).
Note: Place the manual lever in the reverse
position and measure distance that manual
valve is protruding past the rear of the valve
body casting. It should be approximately
.050", as shown in Figure 195. If dimension
is not correct, replace the detent spring and
roller assembly with a "New" one.
15. Lubricate the seal on the new filter with small
amount of Trans-Jel®, and install new filter
into bore in oil pump, as shown in Figure 196.
Continued on Page 112.
Figure 196
BOTTOM PAN
OIL FILTER
Copyright © 2003 ATSG
111