ATSG FORD 4R100 Manual page 105

FINAL ASSEMBLY
Internal Case Components (Cont'd)
19. With the units that are not equipped with PTO,
the procedure would be the same as E4OD.
20. Install the overdrive clutch pack into the case,
as shown in Figure 181, beginning with a steel
plate and alternating with friction plates, until
you have installed the proper amount.
Note: The number of overdrive plates is model
sensitive and may vary from illustration.
21. Install the overdrive clutch backing plate on
top of the last friction plate, with the "dimple"
facing up and in the 12 o'clock (top) position
in the case (See Figure 181).
22. Install overdrive clutch backing plate selective
snap ring, as shown in Figure 181, and ensure
that it is fully seated in case groove, with the
snap ring gap at the 6 o'clock position.
Continued on Page 106.
TIGHTEN CENTER
BOLT TO 7 N·m
(65 IN.LB.)
CLUTCH SPRING
FIXTURE
CLUTCH SPRING
COMPRESSOR PLATE
Figure 180
Technical Service Information
CLUTCH SPRING
COMPRESSOR BAR
AUTOMATIC TRANSMISSION SERVICE GROUP
35
31 OVERDRIVE CLUTCH BACKING PLATE SNAP RING (SELECTIVE)
34 OVERDRIVE CLUTCH BACKING PLATE
35 OVERDRIVE CLUTCH FRICTION PLATES
Figure 181
31
34
"DIMPLE"
36
Copyright © 2003 ATSG
105