ATSG FORD 4R100 Manual page 47

TRANSMISSION DISASSEMBLY
Internal Components (Cont'd)
10. Remove the overdrive carrier and center shaft
assembly, as shown in Figure 60, and set aside
for the component rebuild section.
11. Remove the number 5 thrust bearing, as shown
in Figure 60, which may be on center support.
12. Install clutch spring compressor as shown in
Figure 61, or equivalent, to compress the
intermediate/overdrive clutch cylinder so that
snap ring can be removed.
13. Remove snap ring with large a screwdriver as
shown in Figure 62, and then remove the
compressor tool.
Continued on Page 48.
Figure 60
Technical Service Information
OVERDRIVE CARRIER
AND CENTER SHAFT
ASSEMBLY
NUMBER 5
THRUST BEARING
Copyright © 2003 ATSG
AUTOMATIC TRANSMISSION SERVICE GROUP
TIGHTEN CENTER
BOLT TO 7 N·m
(65 IN.LB.)
CLUTCH SPRING
FIXTURE
CLUTCH SPRING
COMPRESSOR PLATE
Figure 61
CLUTCH SPRING
COMPRESSOR BAR
SNAP RING
Figure 62
CLUTCH SPRING
COMPRESSOR BAR
47