ATSG FORD 4R100 Manual page 62

"INCORRECT" INSTALLATION
IF THE ROLLER CLUTCH IS INSTALLED IN
THIS DIRECTION, THE REVERSE HUB WILL
FREEWHEEL IN BOTH DIRECTIONS,
WHEN INSTALLED IN CASE.
"CORRECT" INSTALLATION
INSTALL IN THIS DIRECTION AND
TURN SLIGHTLY CLOCK-WISE TO
LOCK IN PLACE
62
Technical Service Information
Figure 95
LOW ROLLER
CLUTCH ASM.
REVERSE HUB
ASSEMBLY
Copyright © 2003 ATSG
Figure 96
AUTOMATIC TRANSMISSION SERVICE GROUP
COMPONENT REBUILD
Transmission Case Assembly (Cont'd)
30. Install the low roller clutch into the reverse hub
in the direction shown in Figure 96, and rotate
slightly clock-wise to lock it in place.
Caution: If the roller clutch is installed in
reverse hub in the direction shown in Figure
95, the reverse hub will freewheel in both
directions, when installed in case.
31. Rotate the transmission in fixture so the bell
housing is facing up, as shown in Figure 97.
32. Install the reverse hub and low roller clutch
assembly into the case by rotating clockwise,
as shown in Figure 97, until fully seated.
Note: Reverse clutch hub should freewheel
clockwise and lock counter-clockwise after
installation in case.
33. Install the reverse clutch "Wave" plate on top
of the reverse piston in the case, as shown in
Figure 98.
34. Install the reverse clutch pack beginning with
a steel plate and alternating with a friction plate
as shown in Figure 98, until the proper amount
of plates are installed.
Continued on Page 63.
110 REVERSE CLUTCH HUB AND LOW ROLLER CLUTCH ASM.
Figure 97
110
Copyright © 2003 ATSG