ATSG FORD 4R100 Manual page 104

FINAL ASSEMBLY
Internal Case Components (Cont'd)
13. Install pre-assembled intermediate/overdrive
cylinder assembly, as shown in Figure 179, and
align the feed hole.
14. Place the snap ring into the case and install the
clutch spring compressor tool 307-S223, as
shown in Figure 180, and tighten the center
bolt in the tool to 7 N·m (65 in.lb.).
15. Install the snap ring into the case groove with
the gap at 6 o'clock (bottom) position in case.
OVERDRIVE
CYLINDER
FEED BOLT
CENTER SUPPORT
FEED BOLTS
104
Technical Service Information
Copyright © 2003 ATSG
Figure 178
AUTOMATIC TRANSMISSION SERVICE GROUP
16. Ensure that the snap ring is fully seated and
remove the clutch spring compressor tool.
17. Loosely install a new overdrive clutch cylinder
feedbolt as shown in Figure 178.
18. Since we are building the "PTO" version, we
must now install the overdrive clutch pack as
the overdrive clutches will not pass by the PTO
gear on the coast clutch housing.
Continued on Page 105.
40 INTERMEDIATE/OVERDRIVE CYLINDER SNAP RING
42 INTERMEDIATE/OVERDRIVE CYLINDER ASSEMBLY
Figure 179
40
42
Copyright © 2003 ATSG