Center Support Assembly - ATSG FORD 4R100 Manual

CENTER
SUPPORT
CENTER
SUPPORT
BALL BEARING
RETAINING
BOLTS (3)
CENTER
SUPPORT
BALL BEARING
RETAINING
BOLTS (3)
80
Technical Service Information
CENTER SUPPORT EXPLODED VIEW
48
BALL BEARING
(KOYO 6906)
CENTER
SUPPORT
CENTER
SUPPORT
Copyright © 2003 ATSG
Figure 133
AUTOMATIC TRANSMISSION SERVICE GROUP
CENTER SUPPORT HUB
48 CENTER SUPPORT ASM. (SERVICED AS ASSEMBLY)
49 CENTER SUPPORT DIRECT CLUTCH SEALING RINGS (2)
50 NUMBER 6 THRUST WASHER
Figure 132
COMPONENT REBUILD

Center Support Assembly

1. Disassemble center support, if necessary, using
Figure 132 as a guide.
2. Clean all center support parts thoroughly using
a suitable cleaning solution and blow dry with
compressed air.
3. Inspect all center support parts thoroughly for
any wear and/or damage.
4. Remove and discard the two center support
direct clutch sealing rings (See Figure 132).
5. It is not necessary to remove the center support
from the hub, but if you did, assemble the hub
to support as shown in Figure 133, and torque
the retaining bolts to 9 -14 N·m (80-100 in.lb.).
6. The ball bearing in the center support is not
serviced by Ford, but is available from your
local bearing supply house using the number
supplied in Figure 133.
7. Install a new ball bearing into center support,
as shown in Figure 133, using proper bearing
drivers.
HUB
8. Turn the center support over and install new
sealing rings into the grooves in center support
hub, as shown in Figure 134.
49
Copyright © 2003 ATSG
Continued on Page 81.
50