Transmission Disassembly - ATSG 722.6 Service Manual

SAFETY PRECAUTIONS
Service information provided in this manual by
ATSG is intended for use by professional, qualified
technicians. Attempting repairs or service without
the appropriate training, tools and equipment could
cause injury to you or others.
The service procedures we recommend and
describe in this manual are effective methods of
performing service and repair on this unit. Some of
the procedures require the use of special tools that
are designed for specific purposes.
This manual contains CAUTIONS that you must
observe carefully in order to reduce the risk of injury
to yourself or others. This manual also contains
NOTES that must be carefully followed in order to
avoid improper service that may damage the vehicle,
tools and/or equipment.
Technical Service Information
Standard GM 350
Holding Fixture
Figure 41
AUTOMATIC TRANSMISSION SERVICE GROUP

TRANSMISSION DISASSEMBLY

1. The complete transmission should be steam
cleaned on the outside, to remove any dirt or
grease, before disassembly begins.
2. The standard GM 350 holding fixture works
just fine on the 722.6 transmission, as shown
in Figure 41, which will give you the benefit
of rotating the transmission easily.
3. Remove the torque converter from transmission
and set aside to drain.
Caution: Use care when removing the torque
converter, to avoid personal injury and/or
damage to converter, as it is heavy.
4. Install the holding fixture shown in Figure 41,
install the unit in bench fixture and rotate the
transmission so bell is facing up.
Continued on Page 40
0
7 0 5 7 0
2 0 2
1
6 5 0
2 2 0
7
8 0
7 8
0 6 1
Copyright © 2009 ATSG
39