ATSG FORD 4R100 Manual page 103

FINAL ASSEMBLY
Internal Case Components (Cont'd)
7. Install the intermediate clutch backing plate, as
shown in Figure 176, with the gaps in the steel
plates at the 6 and 12 o'clock positions in case.
8. Install the intermediate clutch plates, as shown
in Figure 176, beginning with a friction plate
and alternating with steel plates until you have
the proper amount installed.
9. Again the gaps in the steel plates should be at
the 6 and 12 o'clock positions in the case.
GAPS IN THE
6 AND 12 O'CLOCK
POSITIONS
53
52 INTERMEDIATE CLUTCH FRICTION PLATES
53 INTERMEDIATE CLUTCH STEEL PLATES
54 INTERMEDIATE CLUTCH BACKING PLATE
Figure 176
Technical Service Information
52
54
GAPS IN THE
6 AND 12 O'CLOCK
POSITIONS
Copyright © 2003 ATSG
AUTOMATIC TRANSMISSION SERVICE GROUP
10. Install pre-assembled center support assembly,
as shown in Figure 177, ensuring that the
number 6 thrust washer is in place, and align
the feed holes.
11. Loosely install the two center support feedbolts
as shown in Figure 178.
12. Install intermediate clutch piston return spring,
as shown in Figure 177, with one spring tab at
the 6 o'clock position.
Continued on Page 104.
46 INTERMEDIATE CLUTCH PISTON RETURN SPRING
48 CENTER SUPPORT ASSEMBLY
49 NUMBER 6 THRUST WASHER, CENTER SUPPORT
Figure 177
46
48
49
Copyright © 2003 ATSG
103