ATSG FORD 4R100 Manual page 86

COMPONENT REBUILD
Overdrive Gearset Assembly (Cont'd)
8. Flip the overdrive planetary carrier over with
the number 3 thrust washer installed, as shown
in Figure 144.
9. Install the number 6 thrust bearing onto the
overdrive planetary carrier in the direction
shown in Figure 144.
10. Install completed overdrive planetary carrier
into the pre-assembled overdrive ring gear, as
shown in Figure 145, by rotating into position
until fully seated.
11. Install the overdrive center shaft onto overdrive
planetary carrier, as shown in Figure 146.
12. Install the wave center shaft snap ring into the
groove in ring gear, as shown in Figure 146.
Note: Use a brass drift against the wave
snap ring to ensure that it is fully seated.
26 NUMBER 3 THRUST WASHER, OUTER RACE TO CARRIER
27 OVERDRIVE PLANETARY CARRIER ASSEMBLY
28 NUMBER 6 THRUST BEARING, CARRIER TO CENTER SHAFT
86
Technical Service Information
28
Copyright © 2003 ATSG
Figure 144
AUTOMATIC TRANSMISSION SERVICE GROUP
13. Install the number 5 thrust bearing on overdrive
center shaft, in direction shown in Figure 146,
and retain with Trans-Jel®.
14. Set the completed overdrive gearset aside for
additional sub-assembly after the coast clutch
housing is built (See Figure 147).
Continued on Page 88.
27
26
26 NUMBER 3 THRUST WASHER, OUTER RACE TO CARRIER
27 OVERDRIVE PLANETARY CARRIER ASSEMBLY
28 NUMBER 6 THRUST BEARING, CARRIER TO CENTER SHAFT
Component Rebuild
Copyright © 2003 ATSG
Figure 145
28
27
26
29