ATSG FORD 4R100 Manual page 110

186 SPACER PLATE TO MAIN VALVE BODY GASKET
187 SOLENOID SCREEN ASSEMBLY
RETAINING
BOLTS (9)
RETAINING NUT
SOLENOID
BODY ASSEMBLY
110
Technical Service Information
186
187
Copyright © 2003 ATSG
Figure 191
"O" RING
Copyright © 2003 ATSG
Figure 192
AUTOMATIC TRANSMISSION SERVICE GROUP
FINAL ASSEMBLY
Bottom Pan Components (Cont'd)
6. Install the solenoid screen into the spacer plate,
as shown in Figure 191, and rotate clockwise
to lock in place.
7. Install the spacer plate to valve body gasket on
spacer plate, as shown in Figure 191.
8. Install new "O" ring seal on the solenoid case
connector, as shown in Figure 192, lube the
"O" ring with Trans-Jel®, and install solenoid
body (See Figure 192).
9. Install the nine solenoid body bolts and the one
nut, as shown in Figure 192, and hand tighten
only at this time.
Note: Refer to Valve Body Bolt Chart found
on Page 116 for proper locations.
10. Install the pre-assembled upper and lower main
valve bodies, as shown in Figure 193, ensuring
that manual valve is engaged on manual lever.
11. Install the 14 valve body retaining bolts and the
two nuts, as shown in Figure 193, and hand
tighten only at this time.
Note: Refer to Valve Body Bolt Chart found
on Page 116 for proper locations.
Continued on Page 111.
RETAINING BOLTS (14)
RETAINING NUTS (2)
UPPER AND LOWER
MAIN VALVE BODIES
Figure 193
Copyright © 2003 ATSG