Forward Clutch Housing - ATSG FORD 4R100 Manual

COMPONENT REBUILD

Forward Clutch Housing

1. Disassemble the forward clutch housing using
Figure 102 as a guide.
2. Clean all forward clutch housing parts using
a suitable cleaning solution and dry with
compressed air.
3. Inspect all forward clutch housing parts for any
wear and/or damage.
Note: Ensure that the air bleed ball in the
forward clutch piston is free and operational
(See Figure 104).
4. Remove and discard the forward clutch inner
and outer seals.
5. Place the forward clutch housing on a flat work
surface, in the direction shown in Figure 103,
and install new sealing rings.
Continued on Page 67.
70 FORWARD CLUTCH SEALING RINGS (2 REQUIRED)
72 FORWARD CLUTCH HOUSING ASSEMBLY
66
Technical Service Information
70
Copyright © 2003 ATSG
Figure 103
AUTOMATIC TRANSMISSION SERVICE GROUP
ENSURE THAT
BALL IS FREE
AND SEALS
72
72 FORWARD CLUTCH HOUSING
73 FORWARD CLUTCH HOUSING INNER "O" RING SEAL
74 FORWARD PISTON OUTER LIP SEAL
75 FORWARD CLUTCH PISTON ASSEMBLY
76
73
Copyright © 2003 ATSG
Figure 104
75
74
72