Overdrive Gearset Assembly - ATSG FORD 4R100 Manual

24 OVERDRIVE ROLLER OUTER RACE "FLAT" SNAP RING
25 OVERDRIVE ROLLER OUTER RACE
26 NUMBER 3 THRUST WASHER, OUTER RACE TO CARRIER
27 OVERDRIVE PLANETARY CARRIER ASSEMBLY
28 NUMBER 6 THRUST BEARING, CARRIER TO CENTER SHAFT
29 OVERDRIVE INTERNAL RING GEAR
30 CENTER SHAFT ASSEMBLY
32 CENTER SHAFT TO RING GEAR "WAVE" SNAP RING
33 NUMBER 5 THRUST BEARING, CENTER SHAFT TO SUPPORT
COMPONENT REBUILD

Overdrive Gearset Assembly

1. Disassemble overdrive gearset using Figure 140
as a guide.
2. Clean all overdrive gearset parts thoroughly
using a suitable cleaning solution.
3. Inspect all overdrive gearset parts thoroughly
for any wear and/or damage.
84
Technical Service Information
OVERDRIVE GEARSET EXPLODED VIEW
24
27
AUTOMATIC TRANSMISSION SERVICE GROUP
25
30
28
Figure 140
4. Position the overdrive ring gear on a flat work
surface, as shown in Figure 141.
5. Install overdrive roller clutch outer race into
overdrive ring gear, as shown in Figure 141.
Note: Groove in outer race must face up,
as shown in Figure 141.
29
26
32
33
Copyright © 2003 ATSG