ATSG FORD 4R100 Manual page 54

TRANSMISSION DISASSEMBLY
Internal Components (Cont'd)
36. Remove the output shaft by pulling straight up,
as shown in Figure 77.
37. Remove the number 13 thrust bearing from the
back of case, as shown in Figure 77.
38. Remove and discard the lube orifice plug from
rear of case, as shown in Figure 78.
Continued on Page 55.
54
Technical Service Information
OUTPUT SHAFT
AND PARK GEAR
NUMBER 13
THRUST BEARING
Copyright © 2003 ATSG
Figure 77
AUTOMATIC TRANSMISSION SERVICE GROUP
LUBE ORIFICE
PLUG
Copyright © 2003 ATSG
Figure 78
LOW ROLLER CLUTCH INNER
RACE RETAINING BOLTS (5)
Copyright © 2003 ATSG
Figure 79