ATSG FORD 4R100 Manual page 44

185
184
184 SPACER PLATE TO CASE GASKET
185 SPACER PLATE
188 SPACER PLATE REINFORCING PLATE
189 REINFORCING PL ATE RETAINING BOLT, M6 X 1.0 X 42 (3)
55
55 MANUAL INTERMEDIATE SERVO ASSEMBLY
182 EPC BLOW-OFF BALL, .250" DIAMETER STEEL BALL
183 EPC BLOW-OFF SPRING
44
Technical Service Information
189
188
Copyright © 2003 ATSG
Figure 53
Copyright © 2003 ATSG
Figure 54
AUTOMATIC TRANSMISSION SERVICE GROUP
TRANSMISSION DISASSEMBLY
Bottom Pan Components (Cont'd)
11. Remove the 3 retaining bolts for the reinforcing
plate, as shown in Figure 53, and remove the
reinforcing plate and the spacer plate.
12. Remove and discard the spacer plate to case
gasket, as shown in Figure 53.
14. Remove 1/4" Dia. steel EPC ball, and spring
from the case pocket, as shown in Figure 54.
15. Remove the manual intermediate servo piston,
as shown in Figure 54, by tapping gently on the
piston with a rubber mallet to release it from
case bore.
16. Remove the eight checkballs from their case
pockets, as shown in Figure 55, using a small
screwdriver.
17. The case checkballs are 5/16" diameter rubber
material, so use care to avoid any damage.
18. Remove and discard the 3 support feed bolts,
as shown in Figure 56.
.312" DIAMETER RUBBER
183
182
CHECKBALLS
.312" DIA. RUBBER
CHECKBALLS
Copyright © 2003 ATSG
Figure 55