ATSG FORD 4R100 Manual page 57

113 LOW ROLLER CLUTCH INNER RACE
114 REVERSE CLUTCH PISTON RETURN SPRING ASSEMBLY
115 REVERSE CLUTCH PISTON INNER LIP SEAL
116 REVERSE CLUTCH PISTON OUTER LIP SEAL
117 REVERSE CLUTCH PISTON
Figure 85
Technical Service Information
113
114
115
117
116
Copyright © 2003 ATSG
AUTOMATIC TRANSMISSION SERVICE GROUP
COMPONENT REBUILD
Transmission Case Assembly (Cont'd)
15. Tighten the nuts to compress the reverse clutch
return spring assembly, as shown in Figure 86.
16. Install 3 low roller inner race retaining bolts, as
shown in Figure 86, and remove the 2 threaded
rods and nuts.
17. Install the two remaining retaining bolts and
torque all five to 24-34 N·m (18-25 ft.lb.) in a
criss-cross pattern, as shown in Figure 87.
Continued on Page 58.
INSTALL THREE
LOW ROLLER CLUTCH INNER
RACE RETAINING BOLTS
Figure 86
Figure 87
TWO THREADED RODS
Copyright © 2003 ATSG
Copyright © 2003 ATSG
57