ATSG FORD 4R100 Manual page 108

FINAL ASSEMBLY
Internal Case Components (Cont'd)
36. After all pump bolts are installed, torque them
to 24-31 N·m (18-23 ft.lb.), using a criss-cross
pattern (See Figure 186).
37. Remove input shaft as shown in Figure 186.
38. Rotate transmission in fixture so that bottom
pan surface is facing up.
39. Ensure that new feed bolts are used for center
support and overdrive clutch cylinder.
108
Technical Service Information
Copyright © 2003 ATSG
Figure 186
AUTOMATIC TRANSMISSION SERVICE GROUP
40. Torque overdrive clutch cylinder feed bolt to,
8-14 N·m (6-10 ft.lb.) (See Figure 187).
41. Torque both of the center support feed bolts to,
11-16 N·m (8-12 ft.lb.). (See Figure 187).
Caution: Overtightening the feed bolts will
cause the case to warp, and result in
transmission failure.
Final Assembly
Continued on Page 109.
OVERDRIVE CYLINDER
FEED BOLT. TORQUE TO
8-14 N·m (6-10 ft.lb.)
CENTER SUPPORT
FEED BOLTS
TORQUE TO
11-16 N·m (8-12 ft.lb.)
Figure 187
Copyright © 2003 ATSG