ATSG FORD 4R100 Manual page 114

INPUT SHAFT
FINAL ASSEMBLY
External Components (Cont'd)
8. Remove the transmission from bench fixture
and set on flat work surface (See Figure 203).
9. Install the input shaft, as shown in Figure 203,
with the long spline end going in first.
10. Lubricate the converter hub with Mercon®
fluid XT-2-QDX, or equivalent, as shown in
Figure 204.
114
Technical Service Information
LONGER SPLINES
Figure 204
AUTOMATIC TRANSMISSION SERVICE GROUP
Figure 203
11. Install torque converter and check the seating
by placing a straight-edge across the front of
case, as shown in Figure 205.
12. Ensure that there is a gap between the converter
pilot face and the straight-edge, as shown in
Figure 205.
CONGRATULATIONS-YOU ARE FINISHED!
F o rd
-B A
P- 7 0 0 6
R FF 8 1
9 8
Copyright © 2003 ATSG
SPACE
Figure 205