ATSG FORD 4R100 Manual page 63

99
97 LOW/REVERSE CLUTCH BACKING PLATE SNAP RING
98 LOW/REVERSE CLUTCH BACKING PLATE
99 LOW/REVERSE CLUTCH FRICTION PLATES (6)
100 LOW/REVERSE CLUTCH STEEL PLATES (6)
101 LOW/REVERSE CLUTCH "WAVE" PLATE
Figure 98
Technical Service Information
97
98
100
101
Copyright © 2003 ATSG
AUTOMATIC TRANSMISSION SERVICE GROUP
Transmission Case Assembly (Cont'd)
35. Install the reverse clutch backing plate on top
of the last friction, as shown in Figure 98.
36. Install the reverse clutch backing plate snap
ring, as shown in Figure 98, and ensure that it
is fully seated in case groove.
Note: The number of reverse plates is model
sensitive and may vary from the illustration.
A stack-up clearance measurement is not
required for the reverse clutch.
37. Install the number 12 thrust bearing and rear
ring gear into case, as shown in Figure 99.
Note: Before installing snap ring provisions
must be made to retain output shaft fully
seated against rear bearing.
38. Install the output shaft snap ring onto output
shaft, as shown in Figure 99
Note: Do not over stretch snap ring during
installation. Ford recommends a new snap
ring for this location.
39. Ensure that snap ring is fully seated in groove
in output shaft, and the case is finally ready
for the final assembly process.
106 OUTPUT SHAFT SNAP RING
107 REAR PL ANETARY RING GEAR
112 NUMBER 12 THRUST BEARING (RING GEAR TO INNER RACE)
Figure 99
106
107
112
Copyright © 2003 ATSG
63