ATSG FORD 4R100 Manual page 81

48 CENTER SUPPORT ASM. (SERVICED AS ASSEMBLY)
49 CENTER SUPPORT DIRECT CLUTCH SEALING RINGS (2)
50 NUMBER 6 THRUST WASHER
Figure 134
COMPLETED CENTER SUPPORT ASSEMBLY
Figure 135
Technical Service Information
50
49
48
Copyright © 2003 ATSG
Copyright © 2003 ATSG
AUTOMATIC TRANSMISSION SERVICE GROUP
COMPONENT REBUILD
Center Support Assembly
9. If the sealing rings are the "Hook" joint type,
ensure that they are properly hooked and that
they rotate freely in the grooves.
10. Install the number 6 thrust washer onto center
support, as shown in Figure 134, and retain
with Trans-Jel®.
11. Set the completed center support assembly
aside for final assembly (See Figure 135).
Component Rebuild
Continued on Page 82.
81