Carrier Ethernet Configuration Guide (Cisco Asr 920 Series - Cisco ASR 920 Series Configuration Manual Ethernet Router

Configuring Ethernet Connectivity Fault Management in a Service Provider Network
Command or Action
Step 12
ethernet cfm traceroute cache size entries
Example:
Device(config)# ethernet cfm traceroute cache
size 200
Step 13 ethernet cfm traceroute cache hold-time minutes
Example:
Device(config)# ethernet cfm traceroute cache
hold-time 60
Step 14
interface type number
Example:
Device(config)# interface gigabitethernet0/0/2
Step 15 service instance id ethernet [evc-name]
Example:
Device(config-if)# service instance 333 ethernet
evc1
Step 16 encapsulation encapsulation-type
Example:
Device(config-if-srv)# encapsulation dot1q 5
Step 17
bridge-domain bridge-id
Example:
Device(config-if-srv)# bridge-domain 100
Step 18 cfm mip level level
Example:
Device(config-if-srv)#cfm mip level 4
Step 19
exit
Example:
Device(config-if-srv)# exit
Step 20 exit
Example:
Device(config-if)# exit
Purpose
Sets the maximum size for the CFM traceroute cache
table.
Sets the amount of time that CFM traceroute cache entries
are retained.
Specifies an interface and enters interface configuration
mode.
Configures an Ethernet service instance on an interface
and enters Ethernet service configuration mode.
Sets the encapsulation method used by the interface.
Binds a service instance to a bridge domain instance.
Creates a MIP and sets the maintenance level number.
Returns to interface configuration mode.
Returns to global configuration mode.

Carrier Ethernet Configuration Guide (Cisco ASR 920 Series)

Configuring Ethernet CFM
161