Carrier Ethernet Configuration Guide (Cisco Asr 920 Series - Cisco ASR 920 Series Configuration Manual Ethernet Router

Configuring Ethernet Connectivity Fault Management in a Service Provider Network
Command or Action
Step 5
continuity-check
Example:
Device(config-ecfm-srv)# continuity-check
Step 6 continuity-check [interval cc-interval]
Example:
Device(config-ecfm-srv)# continuity-check
interval 10s
Step 7 exit
Example:
Device(config-ecfm-srv)# exit
Step 8
mep archive-hold-time minutes
Example:
Device(config-ecfm)# mep archive-hold-time 65
Step 9
exit
Example:
Device(config-ecfm)# exit
Step 10 ethernet cfm global
Example:
Device(config)# ethernet cfm global
Step 11 interface type number
Example:
Device(config)# interface gigabitethernet0/0/2
Step 12 service instance id ethernet [evc-name]
Example:
Device(config-if)# service instance 333 ethernet
evc1
Step 13 encapsulation encapsulation-type
Example:
Device(config-if-srv)# encapsulation dot1q 5
Step 14 bridge-domain bridge-id
Example:
Device(config-if-srv)# bridge-domain 100
Purpose
Configures the transmission of continuity check messages
(CCMs).
Configures the per-service parameters and sets the interval
at which CCMs are transmitted.
Returns to Ethernet connectivity fault management
configuration mode.
Sets the amount of time that data from a missing MEP is
kept in the continuity check database or that entries are
held in the error database before they are purged.
Returns to global configuration mode.
Enables CFM processing globally on the device.
Specifies an interface and enters interface configuration
mode.
Configures an Ethernet service instance on an interface
and enters Ethernet service configuration mode.
Sets the encapsulation method used by the interface.
Binds a service instance to a bridge domain instance.

Carrier Ethernet Configuration Guide (Cisco ASR 920 Series)

Configuring Ethernet CFM
171