Enabling Mac Security On An Evc Port Channel - Cisco ASR 920 Series Configuration Manual Ethernet Router

Enabling MAC Security on an EVC Port Channel

Enabling MAC Security on an EVC Port Channel
Before You Begin
• Bridge-domain, xconnect, and Ethernet virtual circuits (EVCs) are allowed only over the port channel
Note
• If you configure a physical port as part of a channel group, you cannot configure EVCs under that
SUMMARY STEPS
1. enable
2. configure terminal
3. interface port-channel channel-group
4. service instance id
5. encapsulation dot1q vlan-id
6. bridge-domain bridge-id
7. mac security
8. end
DETAILED STEPS
Command or Action
Step 1
enable
Example:
Device> enable
Step 2 configure terminal
Example:
Device# configure terminal
Step 3
interface port-channel channel-group
Example:
Device(config)# interface port-channel 2
Carrier Ethernet Configuration Guide (Cisco ASR 920 Series)
92
Configuring MAC Address Limiting on Service Instances Bridge Domains and EVC Port Channels
interface and the main interface.
physical port.
ethernet
Purpose
Enables privileged EXEC mode.
• Enter your password if prompted.
Enters global configuration mode.
Specifies the port channel group number and enters interface
configuration mode.
• Acceptable values are integers from 1 to 64.