How To Configure 802.1Ad - Cisco ASR 920 Series Configuration Manual Ethernet Router

Configuring IEEE 802.1ad
MAC Address
01-00-0C-CC-CC-CC
01-00-0C-CC-CC-CD

How to Configure 802.1ad

Configuring the IEEE 802.1ad on Service Instances
• Only encapsulation default command is supported on S-UNI ports
Note
SUMMARY STEPS
1. enable
2. configure terminal
3. interface interface-id
4. ethernet dot1ad {nni | uni {c-port | s-port}}
5. service instance number ethernet [name]
6. encapsulation {default | dot1q | priority-tagged | untagged}
7. bridge-domain bridge-id [split-horizon group group-id]
8. rewrite ingress tag { pop {1 | 2} symmetric | push dot1ad vlan-id [dot1q vlan-id] symmetric}
9. end
Protocol C-UNI Action
Port Aggregation Peer
Protocol (PagP),
UniDirectional Link
Detection (UDLD),
Cisco Discovery Peer
Protocol (CDP),
VLAN Trunk
Protocol (VTP)
Dynamic Trunking NA
Protocol (DTP)
Per-VLAN Peer
Spanning Tree
(PVST)
Carrier Ethernet Configuration Guide (Cisco ASR 920 Series)
How to Configure 802.1ad
S-UNI Action NNI Action
Peer Peer
Data Data
NA NA
Data Data
409