Provisioning Service On The Pe-Agg B - Cisco ASR 920 Series Configuration Manual Ethernet Router

Configuring Ethernet CFM

Provisioning Service on the PE-AGG B

SUMMARY STEPS
1. enable
2. configure terminal
3. ethernet cfm domain domain-name level level-id
4. service short-ma-name evc evc-name vlan vlanid direction down
5. continuity-check
6. continuity-check [interval cc-interval]
7. exit
8. mep archive-hold-time minutes
9. exit
10. ethernet cfm global
11. interface type number
12. service instance id ethernet [evc-name]
13. encapsulation encapsulation-type
14. bridge-domain bridge-id
15. cfm mip level level
16. end
DETAILED STEPS
Command or Action
Step 1 enable
Example:
Device> enable
Step 2
configure terminal
Example:
Device# configure terminal
Step 3
ethernet cfm domain domain-name level level-id
Example:
Device(config)# ethernet cfm domain Customer
level 7
Step 4 service short-ma-name evc evc-name vlan vlanid
direction down
Example:
Device(config-ecfm)# service s41 evc 41 vlan
41 direction down
Carrier Ethernet Configuration Guide (Cisco ASR 920 Series)
184
Configuring Ethernet Connectivity Fault Management in a Service Provider Network
Purpose
Enables privileged EXEC mode.
• Enter your password if prompted.
Enters global configuration mode.
Defines a CFM maintenance domain at a particular
maintenance level and enters Ethernet CFM configuration
mode.
Configures a maintenance association within a maintenance
domain and enters Ethernet connectivity fault management
(CFM) service configuration mode.