Configuring Rspan Source Session - Cisco ASR 920 Series Configuration Manual Ethernet Router

Configuring Switched Port Analyzer
DETAILED STEPS
Command or Action
Step 1
enable
Example:
Router> enable
Step 2
configure terminal
Example:
Router# configure terminal
Step 3 no monitor session session-number
Example:
Router(config)# no monitor session 2

Configuring RSPAN Source Session

To configure the source for a RSPAN session:
SUMMARY STEPS
1. enable
2. configure terminal
3. monitor session RSPAN_source_session_number type rspan-source
4. source {single_interface slot/subslot/port| single_vlan [rx | tx | both]
5. destination remote vlan rspan_vlan_ID
6. no shutdown
7. end
DETAILED STEPS
Command or Action
Step 1
enable
Example:
Router> enable
Purpose
Enables privileged EXEC mode.
• Enter your password if prompted.
Enters global configuration mode.
Clears existing SPAN configuration for a session.
Purpose
Enables privileged EXEC mode.
• Enter your password if prompted.
Carrier Ethernet Configuration Guide (Cisco ASR 920 Series)
Configuring RSPAN Source Session
391