Configuring Rspan Destination Session - Cisco ASR 920 Series Configuration Manual Ethernet Router

Configuring Switched Port Analyzer

Configuring RSPAN Destination Session

To configure the destination for a RSPAN session for remote Vlan:
SUMMARY STEPS
1. enable
2. configure terminal
3. monitor session RSPAN_destination_session_number type rspan-destination
4. source remote vlan rspan_vlan_ID
5. destination {single_interface slot/subslot/port}
6. no shutdown
7. end
DETAILED STEPS
Command or Action
Step 1
enable
Example:
Router> enable
Step 2 configure terminal
Example:
Router# configure terminal
Step 3
monitor session RSPAN_destination_session_number
type rspan-destination
Example:
Router(config)# monitor session 1 type
rspan-destination
Step 4
source remote vlan rspan_vlan_ID
Example:
Router(config-mon-rspan-dst)# source remote
vlan2
Step 5
destination {single_interface slot/subslot/port}
Example:
Router(config-mon-rspan-dst)# destination
interface gigabitethernet 0/0/1
Configuring RSPAN Destination Session
Purpose
Enables privileged EXEC mode.
• Enter your password if prompted.
Enters global configuration mode.
Configures a RPAN session.
• RSPAN_destination_session_number—Valid sessions
are 1 to 80.
• rspan-destination—Enters the RSPAN
destination-session configuration mode.
Associates the RSPAN destination session number RSPAN
VLAN.
• rspan_vlan_ID—Specifies the Vlan ID
Associates the RSPAN destination session number with the
destination port.
• single_interface —Specifies the Gigabit Ethernet or
Ten Gigabit Ethernet interface.
◦slot/subslot/port—The location of the interface.
Carrier Ethernet Configuration Guide (Cisco ASR 920 Series)
393