Configuration Examples For Trunk Efp Support - Cisco ASR 920 Series Configuration Manual Ethernet Router

Configuration Examples for Trunk EFP Support

Enables privileged EXEC mode.
• Enter your password if prompted.
Step 2 show ethernet service instance
Example:
Device# show ethernet service instance
Displays information about Ethernet service instances.
Step 3 show ethernet service instance interface port-channel [number]
Example:
Device# show ethernet service instance interface port-channel 1
Displays interface-only information about Ethernet service instances for all port-channel interfaces or for a specified
port-channel interface.
Step 4
show bridge-domain
Example:
Device# show bridge-domain
Displays bridge-domain information.
Step 5
exit
Example:
Device# exit
Exits privileged EXEC mode.
Configuration Examples for Trunk EFP Support
Example: Configuring Trunk EFP Support
In the following example, EFP support has been configured on a trunk interface.
Device> enable
Device# configure terminal
Device(config)# interface port-channel 1
Device(config-if)# service instance trunk 1 ethernet
Device(config-if-srv)# encapsulation dot1q 1 - 5, 7, 9 - 12
Device(config-if-srv)# rewrite ingress tag pop 1 symmetric
Device(config-if-srv)# bridge-domain from-encapsulation
Device(config-if-srv)# no shutdown
Device(config-if-srv)# end
Carrier Ethernet Configuration Guide (Cisco ASR 920 Series)
6
Trunk EFP Support