Configuring A Mac Address Permit List - Cisco ASR 920 Series Configuration Manual Ethernet Router

Configuring MAC Address Limiting on Service Instances Bridge Domains and EVC Port Channels
Command or Action
Step 4
service instance id
Example:
Device(config-if)# service instance 100
ethernet
Step 5 encapsulation dot1q vlan-id
Example:
Device(config-if-srv)# encapsulation dot1q
100
Step 6 bridge-domain bridge-id
Example:
Device(config-if-srv)# bridge-domain 200
Step 7
mac security
Example:
Device(config-if-srv)# mac security
Step 8 end
Example:
Device(config-if-srv)# end

Configuring a MAC Address Permit List

Perform this task to configure permitted MAC addresses on a service instance that is a member of a bridge
domain.
ethernet
Configuring a MAC Address Permit List
Purpose
Creates a service instance on an interface and enters service
instance configuration mode.
Defines the matching criteria to be used in order to map
ingress dot1q frames on an interface to the appropriate service
instance.
Binds the service instance to a bridge- domain instance where
bridge-id is the identifier for the bridge- domain instance.
Enables MAC security on the service instance.
Returns to user EXEC mode.
Carrier Ethernet Configuration Guide (Cisco ASR 920 Series)
93