Restrictions For Cfm Configuration Over Efp Interface With Cross Connect Feature - Cisco ASR 920 Series Configuration Manual Ethernet Router

Restrictions for CFM Configuration over EFP Interface with Cross Connect Feature

Use Cisco Feature Navigator to find information about platform support and Cisco software image support.
To access Cisco Feature Navigator, go to www.cisco.com/go/cfn. An account on Cisco.com is not required.
Restrictions for CFM Configuration over EFP Interface with
Cross Connect Feature
• Configuration of CCM sampling rate for the offloaded sessions using offload sampling command is
• Parsing multiple organizational-specific Type Length Value (TLV) is not supported.
• Priority-tagged encapsulation type is not supported.
• CFM Traceroute with (forwarding database) FDB only option is not supported on Up MEP.
• CFM CC/Ping/Traceroute for Down MEP, CFM Ping/Traceroute for Up MEP use the bypass EAID, so
• CFM Traceroute to expired RMEPSs are flooded only to port where it was last learned. CFM Traceroute
Configuring CFM over EFP with Cross Connect
The sections below describe how to configure CFM on EFP interfaces.
Configuring CFM over EFP Interface with Cross Connect—Basic Configuration
SUMMARY STEPS
1. enable
2. configure terminal
3. pseudowire-class [pw-class-name]
4. encapsulation mpls
5. exit
6. interface interface-id
7. service instance number ethernet [name]
8. encapsulation dot1q { any | vlan-id [vlan-id [-vlan-id]]} second-dot1q {any | vlan-id [vlan-id [-vlan-id]]}
9. xconnect peer-ip-address vc-id {encapsulation {l2tpv3 [manual] |mpls [manual]} |pw-class
pw-class-name} [sequencing {transmit | receive | both}]
10. cfm mep domain domain-name [up | down] mpid mpid-value [cos cos-value]
11. end
Carrier Ethernet Configuration Guide (Cisco ASR 920 Series)
214
not supported.
these packets cannot be mirrored in the egress direction. Only Up MEP CFM CC can be mirrored.
for new RMEPs are not initiated on their own. However ping to both expired and new RMEPs are flooded
to all EFPs in the BD.
CFM Configuration over EFP Interface with Cross Connect Feature