Configuring A Port For Link Fault Rfi Support - Cisco ASR 920 Series Configuration Manual Ethernet Router

Using Ethernet Operations Administration and Maintenance
Command or Action
Step 11
interface type number
Example:
Device(config)# interface gigabitEthernet 0/0/2
Step 12 source template template-name
Example:
Device(config-if)# source template oam-temp
Step 13
exit
Example:
Device(config-if)# exit
Step 14 exit
Example:
Device(config)# exit
Step 15
show running-config
Example:
Device# show running-config

Configuring a Port for Link Fault RFI Support

Perform this task to put a port into a blocking state when an OAM PDU control request packet is received
with the Link Fault Status flag set.
SUMMARY STEPS
1. enable
2. configure terminal
3. interface type number
4. ethernet oam remote-failure {critical-event | dying-gasp | link-fault} action {}
5. exit
Configuring a Port for Link Fault RFI Support
Purpose
Identifies the interface on which to use the template
and enters interface configuration mode.
Applies to the interface the options configured in
the template.
Returns to global configuration mode.
Returns to privileged EXEC mode.
Displays the updated running configuration.
Carrier Ethernet Configuration Guide (Cisco ASR 920 Series)
315